Front windshield channel repair

[75 mustang II]

Had some rusted out areas in windshield channel.Ive cut out the bad and welded in new metal.I need some of the studs that hold the molding clips.Anybody know where a guy might find some?I think I need 5.

 

[Red5oh]

I have seen them in NPD, but I believe they are very similar to stud welder studs... same principle at least.

 

[tos]

I dont know of replacements but im sure a body shop could point you in the right direction. Or you could do what I am doing. I have one missing so I plan on either tack welding the clip in place or brazing it in. Unless you already have or need a stud welder and arent going for full restoration then that would be my suggestion. If you did a good job on your sheet metal work then you wont need to work in this area again.