• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Fuel line disconnect tool?

  • Thread starter Thread starter shallto
  • Start date Start date Apr 25, 2007
S

shallto

Founding Member
Jun 1, 2001
464
0
16
OBX, NC
Apr 25, 2007
#1
  • Apr 25, 2007
  • #1
What does this tool look like? I looked on line and they had 4 or 5 different ones. Also, I need new dowels that go into the timing chain cover. The new engine didn't come with them and I destryed the old ones trying to get them out. Anyone know if they have these at advanced or auto zone?
 

4G-KDMP

10 Year Member
Jul 23, 2005
935
19
39
CA
Apr 25, 2007
#2
  • Apr 25, 2007
  • #2
use the ones dagger posted in this thread.
http://forums.stangnet.com/showthread.php?t=697743

not sure where you might the dowels.
 
3

313Speed

New Member
Sep 11, 2004
0
0
2
Apr 25, 2007
#3
  • Apr 25, 2007
  • #3
The fuel line tool fits before the flare end... usually about 3/8 or so. They are two different sizes. Kinda a PITA to take off at times, but once you get them off the first time, they tend to come off alot easier in the future.
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Apr 25, 2007
#4
  • Apr 25, 2007
  • #4
Look in the A/C repair section for the fuel line tools. They look like little plastic top hats. You will need the 1/2" & 5/8" ones. The hat shaped section goes on facing the large part of the coupling. Then you press hard on the brim until it forces the sleeve into the coupling and releases the spring. You may need someone to pull on the line while you press on the coupling. Put some motor oil on them when you put the line back together.

See http://www.midwayautosupply.com/showproduct.aspx?productid=11741&affiliateid=10050 for more information



You probably will need some injector seal kits too...

The pintle caps hold the O ring in place and keep it from sliding off and into the manifold. If the correct pintle caps are used, they do not have any effect on the injector spray pattern.

Fuel injector seal kits with 2 O rings and a pintle cap (Borg-Warner P/N 274081) are available at Pep Boys auto parts. Cost is about $2.74 per kit.. The following are listed at the Borg-Warner site ( http://www.borg-warner.com ) as being resellers of Borg-Warner parts:

http://www.partsplus.com/ or http://www.autovalue.com/ or http://www.pepboys.com/ or http://www.federatedautoparts.com/

Most of the links above have store locators for find a store in your area.

Use motor oil on the O rings when you re-assemble them & everything will slide into place. The gasoline will wash away any excess oil that gets in the wrong places and it will burn up in the combustion chamber.

The pintle caps fit either injectors with a pin sticking out the injector end or 4 with more tiny holes in the injector end

Place the new pintle caps in some boiling water prior to trying to install them. It makes them soften up and easier to install.
 
S

shallto

Founding Member
Jun 1, 2001
464
0
16
OBX, NC
Apr 25, 2007
#5
  • Apr 25, 2007
  • #5
Thanks for the quick reply. Now I just need those dowels..
 
You must log in or register to reply here.

Similar threads

L
2003 mustang v6 3.8 fuel issue
  • lacole1
  • Jul 20, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
3
Views
203
1996 - 2004 SN95 Mustang -General/Talk- Jul 26, 2026
apple99Mustangdude
A
B
Electrical Why does my fox body keep frying eecs
  • brandyn200
  • Jun 20, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
529
Fox 5.0 Mustang Tech Jun 25, 2026
AeroCoupe
C
Electrical Fuel Gauge...Help! What did I do or Didn't Do?
  • ChickenDeluxe
  • Sep 3, 2026
  • Fox 5.0 Mustang Tech
Replies
2
Views
253
Fox 5.0 Mustang Tech Sep 3, 2026
ChickenDeluxe
C
C
98 gt fuel pressure issues
  • chasecollier1984
  • Jun 2, 2026
  • SN95 4.6L Mustang Tech
Replies
0
Views
188
SN95 4.6L Mustang Tech Jun 2, 2026
chasecollier1984
C
Resolved 93 Mustang 5.0 - Cranks but does not start
  • dan50
  • Jul 18, 2026
  • Fox 5.0 Mustang Tech
Replies
6
Views
493
Fox 5.0 Mustang Tech Jul 18, 2026
dan50
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?