I just installed my OEM fuel rails on my Performer lower, and the crossover tube in on the rail hits the intake. I had to really push it (towards the rear of the car) into the intake (thus bending it) to get it to fit. Is this OK?
Is this the way it fits? How did yours fit?
Should I get different fuel rails?
Will this constant pressure against the intake cause problems like getting that tube too hot, or causing stress on the fittings/connections of the tube to the hard rail, etc.?
Rick
Is this the way it fits? How did yours fit?
Should I get different fuel rails?
Will this constant pressure against the intake cause problems like getting that tube too hot, or causing stress on the fittings/connections of the tube to the hard rail, etc.?
Rick