A few weeks ago, I replaced my gas tank (in my signature car) with a used tank. The used tank came with a fuel pump, sending unit and hoses. I replaced the filler neck gasket, fuel filter and basically breezed through the replacement. I now have an operational fuel gauge and the ability to take right-hand turns without stumbling with less than 1/2 a tank of gas.
One problem (I think) and would appreciate the feedback. When I go to remove the gas cap, there is one heck of a vacuum on the system. It is almost diffucult to take the gas cap off. I don't remember this before and I am a little concerned.
My ideas
1 - kinked hose running from the gas tank to the filler neck
2 - bad vacuum valve on the gas tank (on above hose)
Any thoughts????
Thanks in advance.....
One problem (I think) and would appreciate the feedback. When I go to remove the gas cap, there is one heck of a vacuum on the system. It is almost diffucult to take the gas cap off. I don't remember this before and I am a little concerned.
My ideas
1 - kinked hose running from the gas tank to the filler neck
2 - bad vacuum valve on the gas tank (on above hose)
Any thoughts????
Thanks in advance.....