Gas tank

Sonic · Jul 7, 2023

Hi all I have 95 gt automatic transmission.

I don’t know what is named, that I marked with red. There is coming leaking gasoline. I would like to replace it but unfortunately I don’t know the name to order from rockauto.

Could you please say what does it call

General karthief · Jul 7, 2023

Can't tell from pic but is it leaking where the filler tube enters the fuel tank or is it leaking from the top area of the tank?

Mustang5L5 · Jul 7, 2023

Gas tank filler seal.

OE part number is F4ZZ-9072-DA. You can still buy it from Ford. If oyu look around there are cheaper reproductions.

https://lmr.com/item/LRS-9072A/1979-97-Mustang-Fuel-Filler-Neck-Grommet

Sonic · Jul 7, 2023

Hi again all, I’ve uploaded a video. if I don’t take you precious time could you please watch 30 sec video. I live in Sweden and I don’t want to order wrong parts

AeroCoupe · Jul 7, 2023

If you are going to drop the tank now would be the time to think about a new sock filter for the fuel pump and possibly a new fuel pump if the one in the tank is old or original. I would also replace the vent check valve and the seal for it as its just a pain and time consuming to drop the tank. I just completely reworked that fuel system on my Coupe so I have the part numbers handy:

Fuel tank filler neck grommet from AutoZone - Spectra Premium Fuel Filler Neck Seal, P/N FNA03
Fuel pump hanger (also works on the fuel sending unit) lock ring and seal from AutoZone - Spectra Premium Fuel Tank Lock Ring, P/N LO03
Fuel pump strainer for Walbro 190 or 255 lph pump - Walbro P/N 125-157
Fuel pump strainer for stock pump - Spectra Premium P/N STR44
Fuel vapor valve -E7DZ-9B593-A
Fuel vapor valve seal - F6TZ-9B076-AA

I put the fuel pump strainer part numbers for aftermarket Walbro pump and the one for the stock pump. Not sure if they are different so wanted to post both. Hope this helps.

Sonic · Jul 7, 2023

Thank you aerocoupe and all i hope I can find the parts that you’ve mentioned.

I do consider to sell my GT and by a 95 cobra maybe i might not to need change all the parts that you’ve mentioned (neck is might enough )

If I’m going to change I will like to get your advice of alternative parts - if there is not shipping to Sweden

Sonic · Jul 7, 2023

AeroCoupe said:
If you are going to drop the tank now would be the time to think about a new sock filter for the fuel pump and possibly a new fuel pump if the one in the tank is old or original. I would also replace the vent check valve and the seal for it as its just a pain and time consuming to drop the tank. I just completely reworked that fuel system on my Coupe so I have the part numbers handy:

Fuel tank filler neck grommet from AutoZone - Spectra Premium Fuel Filler Neck Seal, P/N FNA03
Fuel pump hanger (also works on the fuel sending unit) lock ring and seal from AutoZone - Spectra Premium Fuel Tank Lock Ring, P/N LO03
Fuel pump strainer for Walbro 190 or 255 lph pump - Walbro P/N 125-157
Fuel pump strainer for stock pump - Spectra Premium P/N STR44
Fuel vapor valve -E7DZ-9B593-A
Fuel vapor valve seal - F6TZ-9B076-AA

I put the fuel pump strainer part numbers for aftermarket Walbro pump and the one for the stock pump. Not sure if they are different so wanted to post both. Hope this helps.

I’ve thought, even if I’ll considering to sell better to fix and someone else can continue to enjoy riding.

I’ve found some of them on a website (I don’t know - it is allowed to give name of website). I’ve tried to send you a personal message of what I’ve found but I didn’t succeed.

how can I send you a pm to show what I’ve found and not

AeroCoupe · Jul 7, 2023

You can post the web sites on here.

Sonic · Jul 8, 2023

Here are what i’ve found - i guess there are some parts missing that i have to order.

I really appreciate for your help, I wish in Sweden we had the same mustang collaboration as USA, Mexico, Canada..

Do I need something more?

AeroCoupe · Jul 8, 2023

This is just me but I would go with a Walbro 190 lph pump (P/N GSS242). They are fine on a stock motor or one with mild upgrades. Far better pump that the stock 88 lph parts store units. They can be had here in the US for about $82.

I am not sure that you need a filler neck, fuel pump hanger, tank straps, or the filler cap unless you know the ones on your car are in bad shape.

evintho · Jul 8, 2023

All you really need is the filler neck seal but, I would follow AeroCoupe's advice and replace the fuel pump with the Walbro unit while the tank is out.
I've dropped my share of Fox body gas tanks and I've found it waaay easier to take a few minutes to fab up a cheap/simple fuel tank cradle. It truly makes it a one man operation to remove/install the tank and only takes minutes! It even works with a full tank of gas as the cradle is bolted to the floor jack and won't fall off. Scrap 2x4s, a 1" pipe nipple, 7/8" bolt/washers/nut and a few minutes of your time makes life a whole lot easier!

Sonic · Jul 8, 2023

AeroCoupe said:
You can post the web sites on here.

Thank you . I found on eBay (do I need to buy something else (see image ). What do you recommend for fuel filter?

Sonic · Jul 8, 2023

Woow this is really smart I love it - I was actually wondering how I should drop gas tank .

’m pretty sure this is going to make easier for every sn95 and fox body owner.

Thank you so much for sharing your knowledge

limp · Jul 8, 2023

I used my motorcycle lift..No pictures of lifting the gas tank, but here is one of lifting my new rear end... It worked REALLY well for that...

AeroCoupe · Jul 8, 2023

I posted the Walbro strainer part number in my first post so go with that.

General karthief · Jul 9, 2023

limp said:
but here is one of lifting my new rear end... It worked REALLY well for that...

Nobody cares about your rear end

Sonic · Jul 9, 2023

General karthief said:
Nobody cares about your rear end

What is it?

I‘ve one more question;

I’m a begginer and trying to learn with difficult circumstances unfortunately. I didn’t find GSS242 in Sweden. I wonder GSS340 or GSS341 is it suitable to 95 GT.

AeroCoupe · Jul 9, 2023

The GSS340 would be the one to get based on the suction port as it’s the same as the stock unit. 255 lph is a lot of volume but if it’s all you can get it will work.

I’m pretty sure BBK and Accel have them as well.

Is this company any good where you are at?

BBK 86-97 Mustang 5.0 /4.6 190 LPH Intank Fuel Pump | Sweden Mustang

Ska du uppgradera hästkrafterna på din motorcykel? Är din Mustang-bränslepump inte tillräckligt bra eller håller inte längre – uppgradera till en BBK Performance direktbyte 190 Lph intank elektrisk bränslepump – Denna 190 liter per timme-pump kommer att se till att din bil får allt bränsle den...

swedenmustang.com

I’m not up on the exchange rates but it appears to be really expensive. I can get a Walbro 190 for about $90 US.

limp · Jul 9, 2023

General karthief said:
Nobody cares about your rear end

I know, I get alot of hate mail about it....
Trying to show how handy my motorcycle lift has been for lifting items rather than using a car jack... The wide base works well for Gas tanks, rear ends, and even transmissions..... I only have a pic showing it lifting my blasphemous 9".... LOL...
Here is another .......

General karthief · Jul 9, 2023

Sonic said:
What is it?

i was poking fun of limp.
you have any car clubs or repair shops near by that race, you might have to poke around to find one, find out what brands available are dependable, I'm sure RockAuto ships outside US and Summit Racing?

Gas tank

Member

Attachments

wonder how much it would cost to ship you a pair

That is…until I whipped out my Bissell

Member

lube between the nut and the face. I know my lubes

Member

Member

lube between the nut and the face. I know my lubes

Member

Attachments

lube between the nut and the face. I know my lubes

Member

Attachments

Member

wrap a little cheese around it and its a done

lube between the nut and the face. I know my lubes

wonder how much it would cost to ship you a pair

Member

Attachments

lube between the nut and the face. I know my lubes

wrap a little cheese around it and its a done

wonder how much it would cost to ship you a pair

Similar threads

Privacy & Transparency

Privacy & Transparency