Gasket Advice

Shadrack

New Member
Aug 2, 2005
95
0
0
I'll be ordering all new gaskets for my car here within the next few weeks.

What are the best gaskets to go with? My head gaskets look like damn cardboard and I just figured it would be in my best interest to pull the motor and freshen it up (and paint it) before I start hardcore dragging it. Seals/oil pan leaking, blown header gasket, etc. etc.

Anyways, what are the best gaskets to go with, material type/brand, etc. This is on a carb'd car.

Intake Manifold
Head
Headers (that go on the head, not the collector)
Oil pan
Seals (front/rear)
Valve covers (I have Fel-Pro cork gaskets on them now and have no leaks.)

Thanks!
 
intake fel-pro 1250 for 302 block, or 1262 for 351.
head - 1011-1 for iron, 1011-2 for alum
headers- i use Mr. Gasket ultra seal. dunno the number
oil pan- i used a fel pro blue rubber gasket with reinforcment rails.
front seal- dunno, it was already installed in a new FORD timing cover.
rear seal- i forget, honestly.
valve cover- i started off with ford metal/rubber ones that cost $30 a piece($60 total) those broke around the bolt holes, switch to some fel pro black rubber ones for like $8, no leaks at all for me.
 
Whatever you do, don't skimp on cleaning the gasket surfaces. New gaskets need to seat against bare metal and not the residue left from the old gaskets in order to seal leak free. This is the most time consuming and tiresome part of the job. If it isn't clean enough to lick, :drool: it's too dirty to put a new gasket on and expect it to seal properly.
 
a razor blade, wrag, and some parts cleaner. 3M makes this disc thingy you chuck up in a drill and it is suppose to remove old gasket material. i never used it though. just elbow grease and the razor is what i always used.