what gaskets for the edelbrock performer rpm?
upper to lower?
n heres the trick, the lower is stage 2 ported (w/e stage2 means lol
)
lowers to mate with my ported gt40s
part numbers pleasee or suggestions?
n is black silicone good enough for in between the heads on the lower? some people use a cork gasket but i've seen some just dab a whole lot of black silicone or gasket seal or w/e it was im not 100% sure
***my first time pulling this bad boy off hence the million nubee q's
TIA!
:SNSign:
upper to lower?
n heres the trick, the lower is stage 2 ported (w/e stage2 means lol
) lowers to mate with my ported gt40s
part numbers pleasee or suggestions?
n is black silicone good enough for in between the heads on the lower? some people use a cork gasket but i've seen some just dab a whole lot of black silicone or gasket seal or w/e it was im not 100% sure
***my first time pulling this bad boy off hence the million nubee q's
TIA!
:SNSign:
