Gaskets for h/c/i

[95Mustang302]

I'm almost done gathering parts for my h/c/i buildup. All of my main parts are trick flow, the heads the cam and the intake are all trickflow. I'm basically piecing the engine kit seperatly for cheaper.

I need to know what gaskets I should use with this N/A setup.

Would it be ok to use the fms/felpro gasket set like this one...
http://store.summitracing.com/defau...4294908282+4294924755+4294925237&autoview=sku

I know that I need the trickflow upper to lower gaskets, but other than that should everything work?

 

[mustangramair]

I used felpro gaskets. My heads came with a packet that told which ones to get with the part number. I believe the intake to head gasket was a Felpro 1250. I would piece the set together, that is what i did. I had to get a larger header gasket because the exhuast ports were too big for the stock gasket. There were a couple of gaskets listed that you don't need, like rear main seal and the oil pan gasket.

 

[95cobraguy]

that set looks like it has everything u need.