• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Gasoline in my intake manifold and EGR?

  • Thread starter Thread starter 88CougarMan
  • Start date Start date Jan 27, 2004

88CougarMan

Founding Member
Jun 13, 2000
477
6
39
Flower Mound, TX
Jan 27, 2004
#1
  • Jan 27, 2004
  • #1
I have been having rouble with my EGR for the past year or so, and I finally got around to replacing it. A while ago I took off the upper intake manifold and noticed there was a lot of gasoline coated on the inside walls of the manifold, and that troubled me. When I replaced my EGR today I noticed the old one had gasoline dripping off of the cone-shaped valve. What would be causing gas to be recirculated through my EGR and thrown back into my intake manifold? I have always had a rough idle, is this causing the rough idle?
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Jan 27, 2004
#2
  • Jan 27, 2004
  • #2
Probable leak in the fuel pressure regulator diaphram.

Disconnect the vacuum line from both ends, and see if fuel drips out when you blow through the line. Start the car and watch the vacuum port on the regulator. If it drips or squirts fuel, the diaphram is leaking.
 

88CougarMan

Founding Member
Jun 13, 2000
477
6
39
Flower Mound, TX
Jan 27, 2004
#3
  • Jan 27, 2004
  • #3
Unless I've gone retarded, I just can't figure out how a leak in the FPR would cause gas to enter the manifold near the EGR and TB?
 

88CougarMan

Founding Member
Jun 13, 2000
477
6
39
Flower Mound, TX
Jan 27, 2004
#4
  • Jan 27, 2004
  • #4
TTT
 

jrichker

StangNet's favorite TOOL
In Remembrance. Thank you for your contributions
Mar 10, 2000
27,512
2,813
234
Dublin GA
Jan 28, 2004
#5
  • Jan 28, 2004
  • #5
The fuel pressure regulator diaphram leaks fuel into the chamber where the manifold vacuum works on the diaphram. The vacuum in the chamber reduces the fuel pressure according to engine vacuum. If the diaphram leaks fuel into the vacuum chamber, then it sucks it into the intake manifold.
 

88CougarMan

Founding Member
Jun 13, 2000
477
6
39
Flower Mound, TX
Jan 28, 2004
#6
  • Jan 28, 2004
  • #6
Ok, that makes sense. After class today I'll check it out the FPR.
 
You must log in or register to reply here.

Similar threads

D
Question about EGR valve, replacement, and a part on the valve.
  • DPP
  • May 9, 2026
  • SN95 V6 Mustang Tech
Replies
1
Views
125
SN95 V6 Mustang Tech May 23, 2026
DPP
D
M
Help! 2003 GT misfire when hot
  • Modular03
  • Feb 10, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
389
SN95 4.6L Mustang Tech Feb 13, 2026
Mustang5L5
W
1993 LX 5.0 dies after ignition parts replacement
  • Warhorse85
  • Aug 16, 2025
  • Fox 5.0 Mustang Tech
  • 5 6 7
Replies
122
Views
3K
Fox 5.0 Mustang Tech Nov 4, 2025
General karthief
M
Engine Unexplainable Exhaust Pop and Gurgle
  • Mrnissen122
  • Feb 14, 2026
  • Fox 5.0 Mustang Tech
Replies
12
Views
565
Fox 5.0 Mustang Tech Feb 18, 2026
Noobz347
Mustang II 4 cyl gear hunting and possibly messed up vacuum system
  • oesterreicher
  • May 31, 2026
  • 1974 - 1978 Mustang II Talk & Tech
Replies
11
Views
286
1974 - 1978 Mustang II Talk & Tech Jun 14, 2026
manicmechanic007
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?