Gauge installation question

[kingc]

I have been trying to figure out how to run the sende wires from the engine bay to the gauge pod. I am installing a oil presure and water temp gauge. I cannot find an easy way to run these wires through the fire wall.

Any suggestions...

Thanks alot

 

[bakos24]

I ran my wires threw the fender. If you open your door and look towards the top you will see a nice spot the goes into the engine bay. I then just tucked the wires behind the rubber and you can't see them at all.

 

[AmBo]

I just went through the firewall. What's so difficult?

Just get a metal hanger, poke it through, tie the wires to the end, and pull em through.

 

[whyask]

I went through the grommit above the brake pedal..not so easy if your 6'5 and 250lbs under your dash, but it was clean

 

[LaserRed01GT]

There is a rubber grommet on the upper corner of the firewall. Very simple to run wires through.