• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

Gear Questions

  • Thread starter Thread starter FalconGuy016
  • Start date Start date Oct 28, 2004
F

FalconGuy016

New Member
Oct 26, 2004
437
1
0
Northern VA
Oct 28, 2004
#1
  • Oct 28, 2004
  • #1
Hey everyone,

In another thread I asked what upgrade path I should follow, and I understood most well except for the gears. Now I can logically think it through, like what a new gear ratio would do for me, but I want to know what its like on the road. Also, when you say you switched to 3.73 gear(s), do you mean one gear or is that a label for all of them somehow? If just one, which one?

What exactly will the new gear ratio do when driving? Will it accelerate faster? How much so, if its explainable. Also, isnt there a disadvantage in this in torque? Or is it negligible?

And finally, what are some good brands for gears and places to order them.

My upgrade path looks something like this so far: Exhaust, a handling improvment of some kind, then gears, and then so on. Does that sound good to everyone?

Bonus Question!

Is the Mac straight shot (I think its called) worth it? They advertise quite a high rwhp boost (25) and I think StangNet tech article claims 17, but I dont remember exactly right now. Or am I just confusing something and totaly wrong?


Thanks a lot for any help!
 
S

silvstreak00

New Member
Oct 26, 2004
30
0
0
Oct 28, 2004
#2
  • Oct 28, 2004
  • #2
I can answer a few questions as far as the gears. When people talk about 3:55, 373 4:10's etc. that is actually in the rear end. I have 3:73 on my 00 GT and i am very happy. They dont add any hp or torque but they put you in your powerband (where most of your power is). For instance if you shift with the stock 3:27 gears you'll notice the revs fall out of the higher rpms and the motor has to gain all those rpm's back. You'll defn feel the difference when you get gears. Defn an important and worth it mod. I know most people have the frpp gears. Good luck with your decision
 
S

silvstreak00

New Member
Oct 26, 2004
30
0
0
Oct 28, 2004
#3
  • Oct 28, 2004
  • #3
also i would defn put the gears ahead of the exhaust and what not. You wont regret it. I think 3:73 are good all around gear. If your looking to supercharge go with 3:73 if your staying n/a most people go with the 4:10 both is a great improvement over stock! About the mac straight shot. It has brought a lot of questions. Yes it will prob give you a noticeable power increase but it will also lean your a/f ratio out which is obv not what you wanna do.
 
S

silvstreak00

New Member
Oct 26, 2004
30
0
0
Oct 28, 2004
#4
  • Oct 28, 2004
  • #4
also i would defn put the gears ahead of the exhaust and what not. You wont regret it. I think 3:73 are good all around gear. If your looking to supercharge go with 3:73 if your staying n/a most people go with the 4:10 both is a great improvement over stock! About the mac straight shot. It has brought a lot of questions. Yes it will prob give you a noticeable power increase but it will also lean your a/f ratio out which is obv not what you wanna do N/A that is.
 
C

chrisbudl1

New Member
Dec 21, 2003
436
0
0
springfield MO
Oct 28, 2004
#5
  • Oct 28, 2004
  • #5
I'll be the first to say it: DO THE GEARS!!!!!!!! With my 5 speed and 4:10's first gear goes by super fast, almost not even needed. So in the easiest way I can explain it, the pull I used to get in first, is now what I feel in second, and so on. Basicaly the 3:73 is a ratio, for everytime your driveshaft turns, your rear axle turns the ratio set by your gear selection. The higher the number, the faster your rpm's will rise, which inturn means you get to the power band faster, and stay in it easier, after shifting. From my experience, gas mileage can be a factor if you have a heavy foot, but I get around 225 miles out of 3/4 of a tank. which I don't think is bad considering what, and how I drive. I hope that helps. Get frpp gears, they seem to fit better. and stock is usually 3:08, or3:27, but you can get 3:55, 3:73,3:90,4:10,4:56, I'm sure it goes higher than that. Basically at 60 mph every step up you take equals 200 rpm. So running 80, I am right at 3000 rpm's in fifth gear. And as a side note, I love my suspension setup, although all said and done it did get pricey. Good luck, get 4:10's unless you drive only on the highway, or are going to supercharge in the future. Chris
 
C

chrisbudl1

New Member
Dec 21, 2003
436
0
0
springfield MO
Oct 28, 2004
#6
  • Oct 28, 2004
  • #6
And a lot of the hp gains claimed by companies, are probably on built motors, and or supercharged applications. Not that every little thing doesn't help at some point!! so they claim 20 hp, expect more like 5
 
F

FalconGuy016

New Member
Oct 26, 2004
437
1
0
Northern VA
Oct 29, 2004
#7
  • Oct 29, 2004
  • #7
Thanks , that clears up a lot everyone

How difficult is it to install a new gear?
 
You must log in or register to reply here.

Similar threads

3.08 gears with a manual trans
  • limp
  • Aug 27, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2 3
Replies
43
Views
2K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Sep 14, 2026
Qtrhrse23
Drivetrain 5th Gear Ratio
  • PonyGTrider
  • Dec 8, 2025
  • Fox 5.0 Mustang Tech
  • 2
Replies
33
Views
2K
Fox 5.0 Mustang Tech Dec 31, 2025
Qtrhrse23
K
Drivetrain '87 5.0 Installing New Ring Gear and Pinion - Pattern Questions
  • karhoot
  • Apr 23, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
558
Fox 5.0 Mustang Tech May 9, 2026
Mindseye007
W
Speedometer and shifting issues
  • wyatt-tetro891
  • Aug 17, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
6
Views
285
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 18, 2026
wyatt-tetro891
W
Fox Fuel Pump Issues After Replacement/Upgrade
  • Ryu
  • Jun 23, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
24
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Sep 13, 2026
Ryu
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?