Getting block bored...

if you get the blocked decked to increase compression you will need to run higher octane. but anyways, i think the guy who did my block charged me like $15/cylinder to bore and hone. i paid $425 for a the block to be cleaned, bored, honed, cam bearings installed, freeze plugs installed, a few threaded plugs installed, new main bearings, pistons, and rings, get the rods machined, and the pistons installed on the rods.

I paid $15 bucks a cylinder for the bore... but that was 30 over on my mexican block... the rest of the work (tank, deck, etc) was done for an 8.8 rearend trade

$10 per cylinder around here