goin to the junkyard tomorrow have some questions

11mm for all the lights..wrench fits in most spots easy. most of them are real easy to reach from under the car.

yup

Yo your going to the junkyard tommorrow and live in napa. Hey I live in lakecounty, If you happen to see/ have one 4 lug 16 spoke, wheel cover I'd be happy to buy it off you I been looking but havin some trouble in finding the stupid plastic hub cover (only missing one). If you got one repost on here and we can arrange something. Thanks cover i need is the same as this one

yeah there is a different size for ball joints.

Spindles aren't that fun trying to take off in the junkyard, especially if the car you're trying to snag them from is sitting on top of another car! I would have looked for another car, but people buy them up to flip them on ebay or whatever for $150-$200 so they are kind of hard to come by around here. The guy told me if I pulled then I could have them for $40 so I was determined to do it. I had a pickle fork, a crescent wrench, and a 5 lb hammer. I removed the lower ball joint nut, stuck in the pickle fork, and beat it till the whole thing flew apart (don't try this at home folks!). Then I removed the spindle from the strut. I didn't want to try to do it the typical way where you loosen the ball joint & then seperate it because I didn't want the thing flying apart while I'm right on top of it loosening the nut, I'd rather be back a ways from the whole mess. Those lower control arms and coils did a number on the car below it when they shot out.