grey5.0beast said:
awesome, but I want some planned specs on that TT408
Yeah a lot of people have been asking about it so here it is. I've been going slowly on it lately. I'm welding and smoothing out the entire engine bay and going to redo the subframe along with fresh paint. But for the engine setup I currently have all this stuff in the garage i'm looking for about 650-700hp and around the same with the torque at around 10psi but i'm being conservative and will probably make a lot more than that. I've been doing some research for about 2 years now and going over different combos and planing so now this is what I have in the garage right now. I'm going to build the engine myself just to say I did it, I have done a few engines before so we'll see what happens
Main setup consists of this:
Dart 351 Sportmans block std bore
4" 4340 crank from scat
6.2" H-beam rods
JE blower pistons
AFR 185's
sealed power rings
2x turbonetics TO4E C trim 40 a/r .58 aka "my twins"
intercooler out of a 05 ford power stroke "yes it does fit btw with some custom work"
set of ponydown turbo headers "great product"
Stuff i'm still needing
Custom Grind cam I'm still unsure on what specs I should go with
AEM fully programable computer, need a few more OT checks then i'll get it!
new hood well just because I want a new hood!
fab9 rear end
misc turbo stuff, wastegates, bov, piping etc...
Gforce T56, i'm guessing my tremec 3550 wont last too long with this setup
Stay Tuned
