GT-40 cast iron heads ....been milled .030 ..upgraded to comp springs ,retainers, locks good to .550 lift....been lightly ported and gasket matched.....very low miles 450obo
What is a good price for a set of Non-P GT 40's?
lol the P's are better than the non p's.....Id never pay 450 for a set of those, nevermind the fact you can get a set of used aluminums for not much more.
If you have any boneyards near you, a set of heads can be had for around $30 each. That's where most of the ones on eBay come from. I went to one of my local boneyards a while back and saw two sets of P heads and 4 sets of non-p heads. I grabbed the P-heads for myself for $50, and decided to put them on eBay....got $400 for them.
If you have any boneyards near you, a set of heads can be had for around $30 each. That's where most of the ones on eBay come from. I went to one of my local boneyards a while back and saw two sets of P heads and 4 sets of non-p heads. I grabbed the P-heads for myself for $50, and decided to put them on eBay....got $400 for them.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?