Guys with M&M C/C plates...

[The Green GT]

I was doing my plates today and it says put one small spacer under the plates, and one small and two big on top. First off this looks like ass. And seocndly Ive never seen a car with it like that.

How did you put yours?

 

[urban96]

m&m

i put 2 small under and 1 big ontop

i tried it with one big and one small ontop but it hit the hood

 

[The Green GT]

It recomends 2 big and one small on top and one small on the bottom for lowered cars and the other way around for stock height.

I did the two big and one small on the bottom and one small on top, cause it stuck up like 2 ****ing inches.

 

[urban96]

the spacers are so u can raise up the strut to get more travel out of it. i would put as many as you can ontop without the hood hitting

 

[muckstang]

I have my car lowered 1.5" and I have one small on bottom and two big/one small on top. It doesn't look the best, but I have not had any issues of bottoming out.

 

[NotQuik]

just did my mm caster camber plates a couple weeks ago....tried following the instructions since i have the sportlines which lower it about 2" with 1 small on bottom and the other 3 up top took it around hte block and didn't work out for me top of strut wasn't fastened down, had to put 1 big 1 small on top and bottom and so far so good no issues. Hope this helps alittle.