I'm running weld prostars 15*3 1/2 on the front, I just installed new brake pads and the outter pads holding tabs are hitting the back of the wheel. Has anybody else had this problem?, the wheels were on the car when i bought it and they look like they fit the car fine as far as backspacing, the wheels allready have some rub marks like they hit before, but the pads i took off didn't appear to have those holders tampered with, i could run the smallest wheel spacer they make to get the little bit of clearence i need but i don't like using wheel spacers, the car is a converted 4cyl car not sure if the front brakes were upgraded, not sure if that matters or not for wheel clerence, any help thoughts or ideas on this would be greatly appreciated.