• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Having a really hard time shifting

  • Thread starter Thread starter PeteyAce
  • Start date Start date Dec 9, 2005

PeteyAce

Member
Jul 2, 2004
346
0
17
Dec 9, 2005
#1
  • Dec 9, 2005
  • #1
its snowing here in nyc not much a few inches. but i couldnt put my car in the garage as of yet. i been using the stang to go back and forth since its my only car. yetserday i had no problem with it, but today as soon as i was driving my car today it was impossible to shift, first and second are impossible to get into. third and fourth arent to bad, and it got stuck in gear where i had to used to hands to get it out. im thinking the cable or something i have a stock cable and the clutch was changed less then 6months ago
 
8

86bluecobra

Advanced Member
Dec 20, 2004
4,265
12
69
B.C. Canada
Dec 9, 2005
#2
  • Dec 9, 2005
  • #2
sounds like the clutch isn't engaging fully. do you have a stock clutch quadrent on the car? if so sometimes the plastic teeth wear and you have to reach up there and kinda get it tightened to the next tooth mine always did that and i went and bought some aftermarket jobbie
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Dec 9, 2005
#3
  • Dec 9, 2005
  • #3
Where is the point of engagement? How much freeplay do you have? It sounds like a low POE (near the floor) and lots of preload.

Good luck.
 

PeteyAce

Member
Jul 2, 2004
346
0
17
Dec 9, 2005
#4
  • Dec 9, 2005
  • #4
quadrent should be stock, it engages when its only all the way down but sometimes it shifts easily but most of the time i have to put a lot of muscle into it especially when im downshifting
 
8

86bluecobra

Advanced Member
Dec 20, 2004
4,265
12
69
B.C. Canada
Dec 9, 2005
#5
  • Dec 9, 2005
  • #5
yah your clutch quadrent needs adjusting. its a clear kinda plastic thing (technical term) under dash. you can trace the clutch cable to it. you can pull a piece down and put pressuer on the quadrent (thing looks like a 1/4 circle with teeth) and take the slack out of your cabble.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Dec 9, 2005
#6
  • Dec 9, 2005
  • #6
Just try pulling up on the clutch pedal with your foot - that is how it should self-adjust (if the pawl is not stripped).

Good luck.
 
8

86bluecobra

Advanced Member
Dec 20, 2004
4,265
12
69
B.C. Canada
Dec 9, 2005
#7
  • Dec 9, 2005
  • #7
well i wish someone would have told me that when i was having all those problems with my car. i hated laying on my back feeling for the clutch quadrent.
 

PeteyAce

Member
Jul 2, 2004
346
0
17
Dec 9, 2005
#8
  • Dec 9, 2005
  • #8
i acutally lifted it with my foot before it had no effect
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Dec 9, 2005
#9
  • Dec 9, 2005
  • #9
PeteyAce said:
i acutally lifted it with my foot before it had no effect
Click to expand...
Then it sounds like either your cable is stretched out of spec or your quadrant and pawl's teeth stripped.
 

PeteyAce

Member
Jul 2, 2004
346
0
17
Dec 9, 2005
#10
  • Dec 9, 2005
  • #10
ok before i posted the thread i spoke to my uncle and he told to to lift up the clutch with my foot too it didnt work, 20 mins ago i thought id tried it again and it seemed to shifter better i only had trouble getting it into first only, but rarley just again guys, seriously though i dont know what it is about winter that brings out the worst in my car
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Dec 9, 2005
#11
  • Dec 9, 2005
  • #11
One thing to remember is that the plastic on the quadrant and pawl is umpteen years old. The teeth might be on their last legs, so it is not adjusting (ratcheting) like it should.

A new quad and FWA can be had for around 40 bucks. Might be a gift idea.
 

gt40_2003wes

I did sound a wee bit gay there.
Aug 14, 2005
461
2
48
ky
Dec 9, 2005
#12
  • Dec 9, 2005
  • #12
my car is rough to get into gear when its cold but i let it set and tun for a few and it warms up the tranny and then it is fine.
 
V

v8only

Active Member
Jul 3, 2003
2,378
22
49
Dec 10, 2005
#13
  • Dec 10, 2005
  • #13
if it grabs RIGHT off the floor, then your adjustment is too loose. Get a good aftermarket firewall adjuster and quadrant, that'll help tons with getting it into gear. Read up on my sig link if you want more info on the subject.
 
You must log in or register to reply here.

Similar threads

W
Speedometer and shifting issues
  • wyatt-tetro891
  • Aug 17, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
6
Views
316
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 18, 2026
wyatt-tetro891
W
C
Drivetrain T-5 transmission issue
  • Ch3No2
  • Jul 11, 2025
  • Fox 5.0 Mustang Tech
Replies
3
Views
493
Fox 5.0 Mustang Tech Jul 18, 2025
2000xp8
J
Suspension Foxbody mustang Steering shaft issue
  • Jakub2537
  • Sep 5, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
338
Fox 5.0 Mustang Tech Sep 11, 2026
gkomo
M
Inheriting (and likely restoration of) a 1965 Mustang
  • miniwheats235
  • Feb 17, 2026
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
2
Views
399
1965 - 1973 Classic Mustangs -General/Talk- Feb 19, 2026
Realmongo
M
Engine Throttle sticking
  • Magnet86
  • Feb 5, 2025
  • Fox 5.0 Mustang Tech
Replies
16
Views
1K
Fox 5.0 Mustang Tech Apr 1, 2025
General karthief
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?