hello new person here. with a question

[fordpeople]

Well i was just wondering if any of you would know what kind of bolts to use on an engine stand say for a 351 c 351 w 302.

 

[fordpeople]

sorry what I meant to say was what size and i found some from jegs and if any of you know do those work they say they are universal. I have had some experience rebuilding engines but they where already on the stand and never asked all of those little detailed things.
Thanks so much for looking. FP

 

[General karthief]

Look up the thread pitch for the bell housing bolts then measure the depth of the bolt hole, add that to the length needed to bolt it to the block.

 

[fordpeople]

thanks

 

[General karthief]

You may find they bolt size here:

BOLT THREAD REFERENCE!

since there has been plenty of talk... and no doing it... intake manifold 5/16-18 x 2.5 valve cover 1/4-20 x 1 Crank pulley 3/8-16 x 1 Plugging Smog Hole (thermactor plug) 5/8-11 speed sensor clamp 1/4-20 x 3/4 Tps sensor screws M4 x 0.7 pitch x 25mm length intake plaque 8-32x1/2" taper seat...

www.stangnet.com