Clutch shouldn't be slipping after a new install. Check:
Everything tightened up?
Any grease or oil get on the clutch during install?
Did you resurface the flywheel?
Is anything binding during the pedal depression?
Is your engine rear seal leaking onto it?
Are the clutch bolts the correct length?
How many miles you got on her? If you got a liquid on there during install it will typically burn off after a bit.
Adam
1. yup
2. I don't think so. I put the clutch on while the engine was on the cherry picker. everything was new or cleaned off very well(had plenty of time for that!)
3.yes
4.not that I can tell, feels fine
5.god i hope not!
6.the bolts were the same size as the old ones.
7.maybe 150 miles.