I assume I got everything disconnected, subframe, driveshaft, cross member, starter, plugs, cables, hoses and the 6 bell housing to block bolts. I was told theres torque converter bolts that need to be removed also that bolt onto the dust plate. The bottom pic is what I currently see....are these the torque converter bolts??
View attachment 480208
OK looking at the above pic.. Im wanting to remove my torque converter bolts. I can see the flywheel and theres bolts sticking through the flywheel with 14mm nuts attached. Theres also holes on the flywheel itself with nuts behind/ inside the holes. You can also see the nut I already removed...
When wanting to remove the tranny, what are the torque converter nuts that I am to remove? The nuts on the outside of the flywheel or the nuts on the inside of the flywheel?
Also, Im going to have to bump the motor to get to the other nuts obviously, I disconnected 2 cables to my starter already. Theres 3 terminals on the starter itself. I forget which cables go where. The cable from the starter solenoid goes where? And then the ground goes on what terminal? Thanks a bunch guys!
View attachment 480208
OK looking at the above pic.. Im wanting to remove my torque converter bolts. I can see the flywheel and theres bolts sticking through the flywheel with 14mm nuts attached. Theres also holes on the flywheel itself with nuts behind/ inside the holes. You can also see the nut I already removed...
When wanting to remove the tranny, what are the torque converter nuts that I am to remove? The nuts on the outside of the flywheel or the nuts on the inside of the flywheel?
Also, Im going to have to bump the motor to get to the other nuts obviously, I disconnected 2 cables to my starter already. Theres 3 terminals on the starter itself. I forget which cables go where. The cable from the starter solenoid goes where? And then the ground goes on what terminal? Thanks a bunch guys!