I have an 86 GT, BBK shorty headers. I cannot get them to quit leaking at the collectors! I have the nuts tightened as tight as I can get them, and I'm afraid to go more without breaking off the stud. (By the way, I posted in another thread trying to find the right sized nut, 7/16 was too small, 1/2 was just a tad too big, so I had to use a 12mm...why would BBK use metric? Perhaps someone changed the studs, who knows...anyway)
I can feel exhaust blowing by ever so slightly at the collector. Nothing is cracked or bent. I was thinking I'll loosen the nuts up and push up on the H-pipe with a jack and then retighten so I'm not trying to pull the pipe up just by tightening the nuts...anyone have any thoughts on this?
#2: Anyone have any tips or tricks on how to tighten the header bolts up top? I think mine are tight, but I can't hear if there any leaks up there because the collector is so loud. I can't get a wrench in there, and no combination of swivel or wobble extension will work. How did you guys make sure your heads are tight? How can you even get in there?
Thanks!
I can feel exhaust blowing by ever so slightly at the collector. Nothing is cracked or bent. I was thinking I'll loosen the nuts up and push up on the H-pipe with a jack and then retighten so I'm not trying to pull the pipe up just by tightening the nuts...anyone have any thoughts on this?
#2: Anyone have any tips or tricks on how to tighten the header bolts up top? I think mine are tight, but I can't hear if there any leaks up there because the collector is so loud. I can't get a wrench in there, and no combination of swivel or wobble extension will work. How did you guys make sure your heads are tight? How can you even get in there?
Thanks!