• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech

Hesitation and Backfire!!!! help

  • Thread starter Thread starter TOPGUN94GT
  • Start date Start date Dec 13, 2006
T

TOPGUN94GT

New Member
Nov 24, 2006
4
0
0
Dec 13, 2006
#1
  • Dec 13, 2006
  • #1
since i bought my car its had the hesitation prob....but it just started to backfire, only when im punching it and shift to the next gear.....now for the hesitation at WOT from idle to about 4k rpm it does fine but between 4k and 5k it just hesitates like it doesnt want to pick up anymore the needle moves up and down...and the hesitation also occurs when im at normal speeds cruising but its just like a sputter and not as bad as at WOT any suggestions?........i replaced plugs, wires, cap, fuel filter.....i did mess with the distributor...it was too advance and the car was pinging....i also replaced the sensor pressed onto the distibutor i gues the PIP???..the car would turn off at any given moment , and i would have to let it sit for about 15 min before it would start up again....help!!!
 

bill302

Active Member
Nov 2, 2005
2,131
1
46
alabama,gadsden
Dec 14, 2006
#2
  • Dec 14, 2006
  • #2
pull the codes alot of autoparts stores will do it free, or do it your self click on link below for instructions under check computer codes. there is alot of useful info on this site as well....repost code results.
http://www.muscularmustangs.com/maintain.php
 

ProKiller

Founding Member
Apr 26, 2002
3,064
15
78
PA
Dec 14, 2006
#3
  • Dec 14, 2006
  • #3
have you cleaned your Mass Air? that would be my first step.
 
T

TOPGUN94GT

New Member
Nov 24, 2006
4
0
0
Dec 14, 2006
#4
  • Dec 14, 2006
  • #4
the check engine light isnt on........even then i still tried pulling codes myself but it didnt show no codes.......ill try cleaning the MAF.....might it also be the ignition coil....it has had and MSD blaster on it since i bought it..dont know how good it is now
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Dec 14, 2006
#5
  • Dec 14, 2006
  • #5
Did you get 'no codes' or did you see 111?
 
T

TOPGUN94GT

New Member
Nov 24, 2006
4
0
0
Dec 15, 2006
#6
  • Dec 15, 2006
  • #6
i got "no codes"
 

91LX_5L

Founding Member
May 13, 2002
1,943
0
36
British Columbia
Dec 15, 2006
#7
  • Dec 15, 2006
  • #7
I had similar problems, bumping my fuel pressure, cleaning maf helped a lot.
 

HISSIN50

"How long does it take to get help in here?
15 Year Member
Nov 29, 1999
31,179
34
129
Dec 15, 2006
#8
  • Dec 15, 2006
  • #8
TOPGUN94GT said:
i got "no codes"
Click to expand...

For no code scenarios, see here. Not being able to see codes is a red flag in and of itself. The system spitting a system pass code is a means of ensuring that the codes were dumped properly.

Good luck.
 
T

TOPGUN94GT

New Member
Nov 24, 2006
4
0
0
Dec 15, 2006
#9
  • Dec 15, 2006
  • #9
cleaned out the MAF today havnt noticed the backfire anymore but the hesitation is still there....i also tried using a different coil but no luck.....maybe a fuel problem???
 

94Cobra69SS396

Member
Dec 27, 2004
44
0
7
Fontana, CA
Dec 15, 2006
#10
  • Dec 15, 2006
  • #10
You said you pulled out timeing before you cleaned the MAF because it was pinging. A dirty MAF will cause the engine to ping and retarded timing will cause a hesitation. Now that you cleaned the MAF I would bump the timing up to 12* and see if it fixes the hesitation without pinging.
 
You must log in or register to reply here.

Similar threads

P
Fuel New Eldebrock 1406 problems 1985 GT 5.0
  • Paddyman
  • Oct 22, 2026
  • Fox 5.0 Mustang Tech
Replies
4
Views
162
Fox 5.0 Mustang Tech Nov 2, 2026
manicmechanic007
F
Fox 1990 Mustang GT 5.0 A9L – Engine suddenly shuts off but immediately restarts when key turned
  • FishermansFriend
  • Aug 9, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
16
Views
657
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 30, 2026
General karthief
C
98 gt fuel pressure issues
  • chasecollier1984
  • Jun 2, 2026
  • SN95 4.6L Mustang Tech
Replies
0
Views
173
SN95 4.6L Mustang Tech Jun 2, 2026
chasecollier1984
C
R
Efi to car pcv HELP !
  • rgrendell
  • Jul 29, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
23
Views
652
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 2, 2026
Noobz347
S
Electrical Stumped No Start...
  • sydhawk
  • Oct 28, 2025
  • Fox 5.0 Mustang Tech
Replies
8
Views
364
Fox 5.0 Mustang Tech Oct 29, 2025
sydhawk
S
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?