Hey guys got another question here.
I currently waiting for my Trufiber GTS-3 hood from the body shop, I should have it by Wednesday.
Here is a pic of it, on someone elses car
http://i95.photobucket.com/albums/l1...1/103_3343.jpg
I bought the hood pin kit from partscheap.com and had it powder coated black
Here it is
Mustang Hood Pins
My question is......
How and where do I install these at? I know they have kits that mount to the radiator support but that is too close to the center of the hood and would go right through the hood scoops. I want them on the outer edge of the hood and thought I found a good spot to mount these but all I can figure is that they would have to take the place of the rubber stops. If i go anywhere else it would not line up in the middle of the body lines closest to the outer edge.
Here is the look I want.....
SHOULD HAVE THUMBNAILS AT BOTTOM.
Pictures or videos are needed if possible to understand better.
I just re-posted over here, I had about 50 readers and no one that could help.
Maybe I can get a little bit better response here.
I currently waiting for my Trufiber GTS-3 hood from the body shop, I should have it by Wednesday.
Here is a pic of it, on someone elses car
http://i95.photobucket.com/albums/l1...1/103_3343.jpg
I bought the hood pin kit from partscheap.com and had it powder coated black
Here it is
Mustang Hood Pins
My question is......
How and where do I install these at? I know they have kits that mount to the radiator support but that is too close to the center of the hood and would go right through the hood scoops. I want them on the outer edge of the hood and thought I found a good spot to mount these but all I can figure is that they would have to take the place of the rubber stops. If i go anywhere else it would not line up in the middle of the body lines closest to the outer edge.
Here is the look I want.....
SHOULD HAVE THUMBNAILS AT BOTTOM.
Pictures or videos are needed if possible to understand better.
I just re-posted over here, I had about 50 readers and no one that could help.
Maybe I can get a little bit better response here.