How do I Port my upper and lower intake manifolds?

[IJUSTWON]

I have a 2001 Bullitt and want to port my upper/lower intake manifolds, and throttle body, how will i go about doing this and what all tools will i need?

 

[IJUSTWON]

?

 

[Zinc03GT]

It's been 25 minutes since you posted. Relax. Any pics of your stoker kit?

 

[mustang70]

Can you separate the lower manifold? I've never seen a good pic of the Bullit intake, that's why I ask. If not, you might want to consider Extrude Honing.

 

[IJUSTWON]

I had to remachine the pistons to a different compression thats why its takin so long, i have pics of the motor torn down but none yet of the rebuild, should have em within the next few days as well as the car back...........

 

[Zinc03GT]

I had to remachine the pistons to a different compression thats why its takin so long, i have pics of the motor torn down but none yet of the rebuild, should have em within the next few days as well as the car back...........

Should be sweet once it's done.

 

[twogts4us]

As Mustang70 said, "Extrude Honing".

 

[IJUSTWON]

How would i extrde hone?? What tools would i need and what kinda numbers could i expect from this

 

[IJUSTWON]

?

 

[jstreet0204]

How would i extrde hone?? What tools would i need and what kinda numbers could i expect from this

Extrude honing is not something you can do yourself. You'd need to send somewhere to have it done. Basically what they do is force an abrasive foam through the runners that removes material from the runners as it goes through. You might ask the guy in this thread who did his.
http://forums.stangnet.com/showthread.php?t=528438