I have a 2001 Bullitt and want to port my upper/lower intake manifolds, and throttle body, how will i go about doing this and what all tools will i need?
Can you separate the lower manifold? I've never seen a good pic of the Bullit intake, that's why I ask. If not, you might want to consider Extrude Honing.
I had to remachine the pistons to a different compression thats why its takin so long, i have pics of the motor torn down but none yet of the rebuild, should have em within the next few days as well as the car back...........
I had to remachine the pistons to a different compression thats why its takin so long, i have pics of the motor torn down but none yet of the rebuild, should have em within the next few days as well as the car back...........
Extrude honing is not something you can do yourself. You'd need to send somewhere to have it done. Basically what they do is force an abrasive foam through the runners that removes material from the runners as it goes through. You might ask the guy in this thread who did his. http://forums.stangnet.com/showthread.php?t=528438