• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech

How To Do A Compression Test On My Car?

  • Thread starter Thread starter DFG 5OH
  • Start date Start date Jul 2, 2005

DFG 5OH

Active Member
Aug 28, 2004
1,341
0
36
Louisville, KY
Jul 2, 2005
#1
  • Jul 2, 2005
  • #1
Yea yea, i've read lots of "How To's" but i just wanted a good explanation from a mustang guy.

So start typing.

Matt
 
G

Green 94 5.0

Founding Member
Mar 25, 2002
2,601
12
79
Ft. Lauderdale, FL
Jul 2, 2005
#2
  • Jul 2, 2005
  • #2
take the coil wire off, remove a spark plug, screw the compression tester in, crank the motor until the needle on the gauge stops rising, write down the number, repeat for every cylinder. thats all there is to it.
 

dstanggt50

Founding Member
Sep 13, 2000
1,316
0
0
Woodinville, WA
Jul 2, 2005
#3
  • Jul 2, 2005
  • #3
Whenever I do mine, I take all the plugs out, and while its cranking open the t/b by hand, and what the other advise stated, stick compression gauge, crank until guage stops w/coil wire off.
 
J

JRPony

New Member
Jun 10, 2005
83
0
0
Las Vegas, NV
Jul 2, 2005
#4
  • Jul 2, 2005
  • #4
1. Remove all spark plugs. This allows for even cranking/breathing.
2. Disable fuel by disconnecting the fuel pump relay or pulling the fuse. If you only disable spark, then you will still get fuel injected during cranking.
3. Install compression gauge and crank car with the throttle fully open.
4. All the cylinders should be within 10% of each other.
5. It would help to put a battery charger on if you have one so that full cranking speed is achieved.
 

BPA

Founding Member
Aug 5, 2000
159
0
16
S.F.
Jul 2, 2005
#5
  • Jul 2, 2005
  • #5
take all the plugs out... make sure u get compression on each cylinder 3 times and then go to the next cylinder.
 

DFG 5OH

Active Member
Aug 28, 2004
1,341
0
36
Louisville, KY
Jul 2, 2005
#6
  • Jul 2, 2005
  • #6
so test each cylinder 3 times, cut the fuel off from the switch in the trunk...
 

AznStanger3v

Active Member
Aug 11, 2003
2,026
0
47
Northern VA
Jul 2, 2005
#7
  • Jul 2, 2005
  • #7
unplug the coil
undo the fuel pump relay
take out all the plugs
have the tb wide open
crank the car about 9 times for each cylinder
do every cylinder at least 2 times
 
You must log in or register to reply here.

Similar threads

M
Misfire
  • Mike3
  • May 30, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
1
Views
145
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- May 30, 2026
Mike3
M
Engine New factory manifold no start
  • Fishnchips
  • Oct 15, 2026
  • 1994 - 1995 Specific Tech
Replies
13
Views
398
1994 - 1995 Specific Tech Oct 22, 2026
DadLife0724
P
Weird Voltage & Oil Pressure Gauges
  • PNN
  • May 22, 2026
  • SN95 V6 Mustang Tech
Replies
0
Views
162
SN95 V6 Mustang Tech May 22, 2026
PNN
P
Electrical Code 29 again
  • Creomod
  • Jul 31, 2026
  • Fox 5.0 Mustang Tech
Replies
7
Views
392
Fox 5.0 Mustang Tech Aug 3, 2026
Creomod
M
Electrical 93 5.0 No Injector Pulse
  • machinermac
  • Jul 26, 2026
  • Fox 5.0 Mustang Tech
Replies
15
Views
518
Fox 5.0 Mustang Tech Aug 1, 2026
Willybill32
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 1994 - 1995 Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?