how to tell 4cyl tranny from 8cyl tranny

If the tag is still on the trans you can use that, otherwise you can pull the trans and measure the snout of the input shaft. the 4cyl one is smaller. What is the size? I dunno.

buy a pilot bearing for a V-8 5speed and see if it fits the end of the trani right

it's easy to tell. i know only because i did the 4cy t5 swap to replace my wc t5 when it exploded. the 4cyl t5 will have an input shaft (male end for those that don't know) that will measure 14mm vs 16mm from a v8 t5. WATCH OUT though i've heard of people welding v8 input shafts onto 4cyl trannys and selling them locally & on ebay scamming folks. so be wary and watch for weld spatter or anything out of the ordinary. if ever you did get a t5 from a 4banger you can use still use it. i've had my 4cy t5 on my stang for over a year and only paid $65 bucks for it. it's starting to go but atleast it lasted a year. people forget the 89 mustang 5.0 t5 was only rated 265 lbs and a 4 banger was 240 lbs, a diff of only 25 lbs. it wasn't until 90 that t5 became 300lbs
http://www.allfordmustangs.com//Detailed/349.shtml

here's the autozone bearing if you decide to use the 4cyl t5. this bearing is the correct measured fit for the v8 302 crankshaft diameter and the 4cy t5 input shaft diameter.

View attachment 409409

hope this helps

stykthyn said:

your pic wont show up.

Click to expand...

If you got a little box with a red X, Right click on it and do show picture. The picture shows up on both my work PC and my home PC.

OR got to http://www.veryuseful.com/mustang/tech/engine/ and check it out there.