I'm in middle of taking my blown tranny out. I took everything off already - Header, starter, drained fluid, driveshaft off, all and every wire harness off. I was able to get all bolts but 1 off of tranny. one at the top on passenger side.
this fu@#er just wouldn't not budge for anything.
I used every 13mm on my disposal - 1/2, 3/4", 6 points, 12 points, long and short. tried ratchet, braker bar, and bigazz f!@#kin' breaker bar, hammer, BFH, impact gun, WD-40, liquid wrench, screaming bloody murder, and wrench. I even put the wrentch on the bolt, and puch it up with 1.5ton floorjack(thats about 600ft-lb!), and nothing would budge it.
Probrem is that where its located at the top of bell housing, no matter how and what i do, i can't get any of above on it without long extention, which i'm loosing alot of torque. i even lowered engine/tranny down about 6", and still can not get to bolt without extention. and now bolt are strarting to get rounded off.
I mean at this point, i wish bolt head just sear off, so that i can at least take tranny out, and use giant vice grip or something to take the bolt off, but them Grade8 hardened steel bolt would not sear off.
I'm at the point where i'm thinking get air powered saw, and cut the bellhousing out(as i have new trans with bellhousing ready to go), and find way to get the bolt out, or take engine and tranny out of the car completely, and put it on the floor and get to it(all that just to take 1 stinkin' bolt off)
what should I do? I'm out of ideas...
this fu@#er just wouldn't not budge for anything.
I used every 13mm on my disposal - 1/2, 3/4", 6 points, 12 points, long and short. tried ratchet, braker bar, and bigazz f!@#kin' breaker bar, hammer, BFH, impact gun, WD-40, liquid wrench, screaming bloody murder, and wrench. I even put the wrentch on the bolt, and puch it up with 1.5ton floorjack(thats about 600ft-lb!), and nothing would budge it.
Probrem is that where its located at the top of bell housing, no matter how and what i do, i can't get any of above on it without long extention, which i'm loosing alot of torque. i even lowered engine/tranny down about 6", and still can not get to bolt without extention. and now bolt are strarting to get rounded off.
I mean at this point, i wish bolt head just sear off, so that i can at least take tranny out, and use giant vice grip or something to take the bolt off, but them Grade8 hardened steel bolt would not sear off.
I'm at the point where i'm thinking get air powered saw, and cut the bellhousing out(as i have new trans with bellhousing ready to go), and find way to get the bolt out, or take engine and tranny out of the car completely, and put it on the floor and get to it(all that just to take 1 stinkin' bolt off)
what should I do? I'm out of ideas...