So, after my stock exhaust getting a leak in the cat-back, I figure perfect time to put in a Magnaflow setup. On Thursday, the exhaust system and the Dynomax stainless band clamps show up. So yesterday I put in the exhaust.
Typical exhaust install, sucky work to do, but the best tools were a sawsall and an angle grinder. Also noticed that the diff cover had some caked oil on the bottom.
Get the exhaust system finished and the passenger side came out perfect, while the drivers side has the pipe close to the swaybar and the exhaust tip is a bit loose on that side (and clamped as tight as it will go).
So now, I have more fiddling to do on the exhaust and do a fluid change and new gasket on the rear end.
Stupid cars. . .
Typical exhaust install, sucky work to do, but the best tools were a sawsall and an angle grinder. Also noticed that the diff cover had some caked oil on the bottom.
Get the exhaust system finished and the passenger side came out perfect, while the drivers side has the pipe close to the swaybar and the exhaust tip is a bit loose on that side (and clamped as tight as it will go).
So now, I have more fiddling to do on the exhaust and do a fluid change and new gasket on the rear end.
Stupid cars. . .