• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Input Shaft Bearing? Aweful noise..and not T/O.

  • Thread starter Thread starter Grandmaster
  • Start date Start date Apr 30, 2004

Grandmaster

New Member
Dec 7, 2002
374
0
0
Monticello, Arkansas
Apr 30, 2004
#1
  • Apr 30, 2004
  • #1
Ok guys i really have to figure out what is up with my car. Ever since i've had it (since about last may) if i'm sitting in nuetral and do not have the clutch pushed in, i hear this whinning noise..like wirring. Fairly loud, if i walk across the yard i can hear it along with the exhaust (flows). So, i thought it was the throwout bearing. In fact, about six months ago, my T/O bearing DID go bad making all kinds of squeeling and i got it fixed: Complete new spec clutch kit. So, i went and picked up my car from the mechanic. The squeeling etc was gone, clutch is great, BUT the wirring is still happening when sitting in nuetral. The sound goes away as soon as i push the clutch in. WHAT IS THIS?? I'm sick of it, i've got to get it fixed, but i have no idea what it is. I'll be going to my mechanic to get my suspension put in soon and if i can figure out what it is i'll have him do that also (or at least take a look at it for me). Thanks a lot for ANY help.
-GM
 

88stangmangt

Active Member
Nov 25, 2003
2,332
1
48
Stafford,VA
Apr 30, 2004
#2
  • Apr 30, 2004
  • #2
wow that is a hard on to say since you just had a spec pack put in?????????????? usually the main target is the T/O.
 

dastang2

Active Member
Dec 11, 2003
2,020
0
46
tx
Apr 30, 2004
#3
  • Apr 30, 2004
  • #3
i had that last weekend, it sounds like the whole tranny is going to fall out. i have a tailshaft leak and all of the fluid leaked out so i put some new fluid in and no more noise. you better act fast or bye bye tranny
 

ECU5.0

Banned
Jan 10, 2004
1,803
1
0
raleigh, nc
Apr 30, 2004
#4
  • Apr 30, 2004
  • #4
yep...mine does that too...i hate it. mine leaks and whenever i fill it up the noise stops
 
K

ka0tyk

Founding Member
Oct 10, 2001
1,610
0
0
Los Angeles, CA
Apr 30, 2004
#5
  • Apr 30, 2004
  • #5
when you put the new TO on, did you grease the input shaft? I was in a hurry when I T5 swapped and I forgot, and now the TO bearing chatters on the steel shaft... DOH!!! Throwout bearings dont do anything until the clutch is pressed in, pilot bearings would squeal like crazy if they were bad.

take off the clutch fork dust cover, and spray some graphite spray lube onto the front bearing retainer shaft and have yer buddy step on the clutch so you can get it completely covered. you should be good to go after that. you might have to do it every once in a while as the graphite wears out.
 

axeman

Founding Member
Feb 9, 2001
1,348
0
36
Elizabethtown, PA
Apr 30, 2004
#6
  • Apr 30, 2004
  • #6
i wouldn't doubt it's the TO bearing again, but it could be the pilot bearing in the back of the crankshaft. mine went bad a couple of years ago. i remember it being a whirling noise, maybe a grinding/sqeeling noise. it's almost like a wheel bearing but much smaller. all the little roller bearings fell out. just a thought.
 
You must log in or register to reply here.

Similar threads

B
Engine Strange Noise
  • burntokita
  • May 8, 2026
  • Fox 5.0 Mustang Tech
Replies
8
Views
407
Fox 5.0 Mustang Tech May 11, 2026
keel
R
Drivetrain Clutch
  • Robman8028
  • Jun 29, 2025
  • Fox 5.0 Mustang Tech
Replies
4
Views
272
Fox 5.0 Mustang Tech Jul 2, 2025
AeroCoupe
C
Drivetrain T-5 transmission issue
  • Ch3No2
  • Jul 11, 2025
  • Fox 5.0 Mustang Tech
Replies
3
Views
381
Fox 5.0 Mustang Tech Jul 18, 2025
2000xp8
P
2002 T5 transmission vibration issue
  • puffoo
  • Feb 22, 2026
  • SN95 V6 Mustang Tech
Replies
0
Views
181
SN95 V6 Mustang Tech Feb 22, 2026
puffoo
P
S
Drivetrain 8.8 Pinion and 302 rear main seal leaks after replacing. 93 5.0 with t-5
  • Steigy4827
  • Jun 23, 2025
  • Fox 5.0 Mustang Tech
Replies
10
Views
679
Fox 5.0 Mustang Tech Apr 1, 2026
Steigy4827
S
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?