installed an 03 center console after picking up a tan/faun one at a good price on E-bay. Scuffed it down and prepped/painted black. I need to touch up some of the cup holder area but I want to mask that off before hitting it again. I scuffed the paint down to take some of the gloss out as it was too shiny and then used some car wax and elbow grease to dull blend any scuff marks.
I now have 2 cup holders...put in tech in case anyone has questions on swapping a console to a newer model.
Little swap info. I had to swap out the wiring from my stock console. I had to cut and splice the power jack under the arm rest (in the cubby).
On the fog light switch I had to cut a new guide notch as the console uses that for the vert switch.
The arm rest uses a male/female latch setup vs. our magnetic latch. I swapped the lower part of the arm rest to my stock black armrest. There are 2 more holes in this area...I had to leave them out. The lower still has 5-6 screws holding it to the arm pad.
I now have 2 cup holders...put in tech in case anyone has questions on swapping a console to a newer model.
Little swap info. I had to swap out the wiring from my stock console. I had to cut and splice the power jack under the arm rest (in the cubby).
On the fog light switch I had to cut a new guide notch as the console uses that for the vert switch.
The arm rest uses a male/female latch setup vs. our magnetic latch. I swapped the lower part of the arm rest to my stock black armrest. There are 2 more holes in this area...I had to leave them out. The lower still has 5-6 screws holding it to the arm pad.