On my 95 GT with a new short block, I installed the distributor and with number 1 at tdc and I adjusted the timing mark on the balancer to 10 degrees. Installed the distributor with rotor facing number 1 on the cap. Started the car and it ran for a few secs and died and it won't stay running. Any ideas? I'm thinking the distributor is off a tooth on the rotor. I marked a dot on the base for number 1 from the cap and the left rotor blade is on the dot it but not in the middle. Does it have to be dead on the spot? From the pic is the rotor position off?