Installed Mil Eliminators

D

DoubleThePower

New Member

Apr 28, 2003

165

0

0

Sterling Heights Michigan

Aug 6, 2004

#1

• Aug 6, 2004

• #1

I finally installed MIL Eliminators a week ago on my brother's 96 Vert. It lowered the idle of the car and it lost alot of power. Soo i took them off because it was stalling at the light occasionally. Since i've taken it off the idle is still a little bit lower than it normally was. What could that be from? Any ideas?

 

COBRA90GT

Mustang Master

Sep 22, 2001

6,654

0

87

HOCKEYTOWN ® , MI

Aug 6, 2004

#2

• Aug 6, 2004

• #2

Did you install them on the correct set of O2 sensors (the rear ones)?

Did you disconnect the battery/reset the car computer?
It sounds like you *may have* installed them on the front O2s...in any event, here is a good troubleshooting FAQ, thanks to PEP:

http://ponyexpressperformance.com/MILtech.html

 

bunny_power

New Member

Aug 13, 2003

170

0

0

Edmonton

Aug 6, 2004

#3

• Aug 6, 2004

• #3

Sounds like you installed them on the front O2's instead of the rear.

 

D

DoubleThePower

New Member

Apr 28, 2003

165

0

0

Sterling Heights Michigan

Aug 6, 2004

#4

• Aug 6, 2004

• #4

I definitely installed them on the rear.

 

StangFreak32

New Member

Jul 16, 2004

75

0

0

Baton Rouge, La

Aug 6, 2004

#5

• Aug 6, 2004

• #5

shouldnt be causing any troubles sounds like something else is wrong

 

70stangcoupe

Founding Member

Nov 12, 2001

2,895

0

0

Winston-Salem, NC

Aug 6, 2004

#6

• Aug 6, 2004

• #6

I installed MIL Elims this morning when I switched out my midpipe. Didn't lose any power and Idle didn't change at all.

Did you disconnect the battery for 10 minutes like you were supposed to? That re-sets the computer.

 

D

DoubleThePower

New Member

Apr 28, 2003

165

0

0

Sterling Heights Michigan

Aug 6, 2004

#7

• Aug 6, 2004

• #7

I disconnected the battery for like 10 mins.....i'm gonna try it again one more time then i dunno after that What else could make it do that?

 

70stangcoupe

Founding Member

Nov 12, 2001

2,895

0

0

Winston-Salem, NC

Aug 6, 2004

#8

• Aug 6, 2004

• #8

What kind did you use? The plug-in type or the type you have to wire? Are you throwing the CEL?

 

D

DoubleThePower

New Member

Apr 28, 2003

165

0

0

Sterling Heights Michigan

Aug 7, 2004

#9

• Aug 7, 2004

• #9

Plug in kind from 50resto