Installing a Kenne Bell 1.7 W/O an intercooler
- Thread starter H8IT4U
- Start date
the Kenne Bell site says at 6psi non-intercooled , 351 rwhp/ 366 rwtq (+106rwhp /+74 rwtq)
http://www.kennebell.net/superchargers/ford/gt96-03_2v/gt96-04.htm
not bad actually...wonder if you can be safe going to 7 or 8 psi without an intercooler, run a safe tune, and still run close to 375rwhp...their intercooled kit is about $1100 more....
http://www.kennebell.net/superchargers/ford/gt96-03_2v/gt96-04.htm
not bad actually...wonder if you can be safe going to 7 or 8 psi without an intercooler, run a safe tune, and still run close to 375rwhp...their intercooled kit is about $1100 more....
I look it according to KB it's based on the fuel you are running for those if I remember correctly it's between 91-94 oct.Stangdriver1119 said:
AmBo
Active Member
LB0193 said:mine is 330 rear with the 6 psi pulley...kinda dispointing
can you change the pully on that kit or is that the base one? the site advertise a little higher on a 4.6 is that what is advertised on site for your can?
'13_ImpactBlue_GT
Angry Little Elf
LB0193 said:mine is 330 rear with the 6 psi pulley
Yeah but you cant beat the torque and hp curve youve got.
lgndracer
New Member
LB0193 said:mine is 330 rear with the 6 psi pulley
Is that the "out of the box" tune? You may want to contact KB. I friend of mine went through three chips with them before he got the advertised output.
This is why I went with a custom tune to start with. That way it is tuned on your car, at your altitude and type of weather.
Also, remember that automatics will have less than 5 speeds. (not saying yours is, just stating a comment)
supastang03
Member
