installing a lokar center E-Brake

12sec67

Active Member

Oct 6, 2003

1,301

1

36

San Diego, Ca

Mar 24, 2008

#1

• Mar 24, 2008

• #1

66 mustang coupe with a versi 9".

Parts list: lokar staineless e-brake cables, lokar chrome handle and clevis.

rear disc brake set up


made a braket out of 1/8" steel and attached to the existing 9" spring perch braket


routing the lines for the ebrake in the stock locations up to the center lever

 

12sec67

Active Member

Oct 6, 2003

1,301

1

36

San Diego, Ca

Mar 24, 2008

#2

• Mar 24, 2008

• #2

next- is finding the correct mounting point for the lever.




one thing that should be done when installing a center pull e brake lever is to reinforce the floor where you will cutting the hole.

Here we show the plate and where it will be welded to the center trans hump for reinforcement.


this is how the boot cover plate will attach to the newly installed reinforment plate.

 

12sec67

Active Member

Oct 6, 2003

1,301

1

36

San Diego, Ca

Mar 24, 2008

#3

• Mar 24, 2008

• #3

cut the hole in the floor board and put the reinforcement plate on


plate welded to the floor


pictures of the cables routed in the stock location


rear picture of the cables


completed with clevis




now all you need to do is apply undercoat, install carpet and install boot cover.



check out any of our other projects in our project forums:
http://www.cprstreetmachines.com/forum/index.php?board=2.0

 

gonzothegreat

Member

May 4, 2004

421

1

16

London (uk)

Mar 24, 2008

#4

• Mar 24, 2008

• #4

Excellent work, thanks for sharing.