Installing my distributor...

FordRacing302

5 Year Member
Oct 1, 2005
384
42
59
Cleveland, TN
Well I went to install my distributor for my car and it doesnt seem to want to go all the way in.....I set it at TDC on the #1 cylinder on power stroke, and then went to slide it in and it wont go all the way down, I can feel where the gear meshes with the other gear but I think its not dropping onto the oil pump rod....I looked down in there with a flashlight and the rod is resting on the side and not standing straight up, and when I try to straighten it with a screwdriver it just falls back....Is there any tips or tricks I can use to put this thing in without resorting to a hammer?????? :fuss:
 
This might be easy or it might be hard....

On a 302, the oil pump drive shaft is 5/16 hex, so you can rotate it with a 5/16 socket on a long extension. I usually duct tape the socket to the extension so it does not fall off in there.

That will allow you to realign the shaft to better fit into the dist most of the time.

You can also set the dist in there, and rotate the engine over with a big wrench on the crank bolt.

In this case, I would make sure the shaft is still sitting in the oil pump drive before trying to do anything else. There is supposed to be a snap on collar that keeps the shaft from being pulled upward. Works fine without it, but its best if it is there.
 
Im still having alot of problems with it...I put a dab of grease in there to keep it centered but it still wont seat down onto it....Anyone else have a better idea?? maybe I should turn the engine over with the starter????
 
rd said:
This might be easy or it might be hard....

On a 302, the oil pump drive shaft is 5/16 hex, so you can rotate it with a 5/16 socket on a long extension. I usually duct tape the socket to the extension so it does not fall off in there.

That will allow you to realign the shaft to better fit into the dist most of the time.
The last tine I did it, I used a 1/4" socket. Be patient, it will fit.
 
Im really stumped as to what to do...Ive stuck alot of bearing grease down there and its standing straight up, Ive used a breaker bar to turn the engine over while I shook the distributor, I had someone else shake the distributor while I bumped the engien over a few times AND it still wont go in??? Im bout to give up and just sell the car................Is there ANYTHING else that I could try??
 
I finally got it in, I just pulled to oil drive shaft out with a magnet and put it in the bottom of the distributor and then it dropped right in.....But after I got it all wired up I proceeded to wire the coil up and I think I fried the starter :bang: , Oh well thanks for your help guys