Ok, so I just installed the JLT RAI and it is great. But I want more power so if I went with the Mac 2.5 catback stainless steel, the C+L upper intake plenum, and the mac 75mm tb would I gain a fair amount of power? Would the "Stainless steel" exhaut rust? Will the plenum, tb, and intake line up and will the finishes match?
intake and exhaust ?
- Thread starter J smitty
- Start date
-
Sponsors (?)
scupking
Active Member
Your looking at around 10+ hp gain. Your not going to see much just from a catback and a 75mm tb plenum kit. The mid pipe is where you are going to see more of a gain. You aren't going to see any more power till you get a tune. Once you get a custome tune you will be looking at around 30+rwhp.
BurningRubber
10 Year Member
- Dec 6, 2004
- 1,865
- 24
- 58
I noticed a difference (not huge) when I installed my 75mm tb and ported plenum. It pulled harder up top.
You wont notice much if any at all gain from just a catback. The mid pipe is where its at though. I reccomend an X pipe if you want to squeeze the most out of it. Mine pulled noticably harder up top after I put it on.
X pipe and Mac's sound great... here are some of my clips. UPR catless X btw...
http://www.youtube.com/watch?v=0tSnKl4Ccs8
http://www.youtube.com/watch?v=MTUINN5GrnI
You wont notice much if any at all gain from just a catback. The mid pipe is where its at though. I reccomend an X pipe if you want to squeeze the most out of it. Mine pulled noticably harder up top after I put it on.
X pipe and Mac's sound great... here are some of my clips. UPR catless X btw...
http://www.youtube.com/watch?v=0tSnKl4Ccs8
http://www.youtube.com/watch?v=MTUINN5GrnI
CobraRed_96_GT
Active Member
H What 4.6
New Member
- Jul 29, 2005
- 56
- 0
- 0
stainless steel will not rust and the finishes on the plenum and t/b depend on which type of finishes you ordered ?!?
StangYellow
Founding Member
- Sep 11, 2002
- 1,052
- 1
- 39
Similar threads
