I am rebuilding my 5.0, it will have ported heads, ported edelbrock perf RPM, x-cam, 70mm TB, 150 shot nitrous, and all the supporting hardware,6500 rpm max. My question is, should I reuse my roller lifters or by new ones? If I reuse how can I tell if they are still good?
Mine had 100K on them when I rebuilt my motor so I went ahead and replaced them because the cam card said to. If it didnt have many miles I dont see why you would need to replace.
hydrolic roller lifter don't go bad...unless your cam is bad...if you had solid tappet lifter than you would have to replace them with a cam swap...save your $$$.
hydrolic roller lifter don't go bad...unless your cam is bad...if you had solid tappet lifter than you would have to replace them with a cam swap...save your $$$.