Keisler 'Perfect Fit' TKO 500 in a '66

elaudtr, your link is for a GM application. Not sure if you were aware. THis is from their 65-70 Mustang section:
Custom shift position exactly the same as Toploader for zero tunnel hump modifications on most models.
http://www.thedrivenman.com/KE/Ford/Transmissions/mustang_65-70.asp
It "appears" they modify the shifter plate/mount, whatever, to get the trans to come up through the existing hole for the shifter with no interferance, however, even with that, I can't see how it would be enough in a 65-66 to get the angle right with no other mods.

I haven't used Keisler but I've talked to them at a couple shows and to be honest, they scare me, snake oil sales practices and stupidity make for one hell of a package.

As far as I can tell the "super duper special TKO" is stock as a rock too, they require you to notch the piss out of the floor crossmember and that seems to be their "perfect fit". It could be worse, but the instruction sheet tells you to finish it off with RTV and self tapping screws. Do you really want to buy from hacks that think like that?

Also, one of their techs posts on another site, and the nicest thing I can say is I hope he's not their best and brightest. Dude is a hack of monstrous proportions, has a half-assed knowledge of Tremecs and, well, you get the point. He's always quoting their official methods and tech info and it's not a lot better

gp001 said:

Richmond 6 speed is the only way to go

Click to expand...

Sorry for the O/T question.
What mods, if any, are required to fit the Richmond 6 speed? If this would fit in a 66 it should fit my 68 no problem.

Blue Oval Man said:

Sorry for the O/T question.
What mods, if any, are required to fit the Richmond 6 speed? If this would fit in a 66 it should fit my 68 no problem.

Click to expand...

http://www.2mfffabshop.com/rod.htm

Ouch! the trans alone is $3000. Add $100 for shipping $100 for the GM slip yoke and a shifter is easily $200. You'll need new carpet for this one also, since the shifter hole is like 5" back and 3" to the driver side.

I'm sure this is a nice trans but it's out of the budget.

Pushing the $3500, I could put the money into a 408 instead, keep the toploader and just reduce the rear gear to a 3:33 from a 3:70. The motor will make up for the gear loss.

Thanks for the info.

or toploader +gear vendors

I've priced a gear venders unit also. At the price I might as well buy a new transmission.

I did find a price on an rebuilt astro T-5 for $1600 with a $200 core charge.