LCA Ball joint issue

wakeen19

New Member
Mar 14, 2021
1
0
1
Connecticut
Hello, Sorry my first post is a question but I usually can find answers by searching but I cant seem to figure this out. I was changing the ball joints on the front lower control arms (85 fox body). I pressed the old ones out and ordered new ones from NPD. The new ones are smaller than the old ones. The new ones measure 1.95" and the ones I took out measure 2.08" and have a 5651 stamped on the bottom. The hole in the LCA's measures 2.06". Where would I be able to find a ball joint that size that will also fit the spindle? Thanks in advance
 
  • Sponsors (?)