Ok,
So last weekend I decided to spin a rod bearing in my 98 GT. So yesterday I bought a PI motor out of a 2003 GT.
Now here's the questions... When pulling the existing motor out, where do I pull from? I know on previous cars that I've worked on, I've always mounted a plate or something to the intake plenum, however I don't think that's a good idea in this case because of the plastic intake. Also, I don't have any engine lifting hooks bolted down somewhere.
If anybody knows the best spot to lift one of these out, I'd greatly appreciate it. Also if anybody knows where I might have some troubles putting an '03 motor in a '98 car, let me know. They're both Romeo motors, don't imagine I'll run into too much trouble.
Thanks!
So last weekend I decided to spin a rod bearing in my 98 GT. So yesterday I bought a PI motor out of a 2003 GT.
Now here's the questions... When pulling the existing motor out, where do I pull from? I know on previous cars that I've worked on, I've always mounted a plate or something to the intake plenum, however I don't think that's a good idea in this case because of the plastic intake. Also, I don't have any engine lifting hooks bolted down somewhere.
If anybody knows the best spot to lift one of these out, I'd greatly appreciate it. Also if anybody knows where I might have some troubles putting an '03 motor in a '98 car, let me know. They're both Romeo motors, don't imagine I'll run into too much trouble.
Thanks!