Light Bar Wiring HELP!!!!!!!!!!!!!!!

Use the high mounted third brake light feed. It's a dark green wire that runs in a harness along the driver's side then up to a connector located near where the harness passes into the trunk lid.

I'm not familiar with the Haney shutoff switch, but it seems to me you would need a microswitch mounted somewhere to detect physically if the top is up or down. The hydraulic pump motor only runs when raising or lowering the top, so not a useful inducator of position of the mechanism.

It is possible to use a dual-coil latching relay with the coils driven from the up & down contacts on the top switch, or even from the pump motor itself. Perhaps this is how the Haney detector module works. Can you post a scan of the instructions that came with the unit?
How many wires does it have? (I would expect 4; 2 to the pump motor, 1 to the light bar, and 1 to ground.