• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

lower coolant lvl light?

  • Thread starter Thread starter paintballpyro1
  • Start date Start date Dec 9, 2008

paintballpyro1

Active Member
Jan 6, 2004
118
1
29
Michigan
Dec 9, 2008
#1
  • Dec 9, 2008
  • #1
So my low coolent light came on and it wasnt all that low but i still added some and restarted my car and light went off and then after 2-3min of driving it came back on and the level was still fine. Am i right to assume that sensor on the bottom of the reservoir is broke? I took the tank off and cleaned it out and cleaned the float(which floats just fine btw) Im just trying to figure out if thats whats wrong since ford only sells the tank and sensor as a hole and cant be seperated. Thanks
 

joshjwc9

Active Member
Jun 12, 2006
1,095
17
39
Palm Harbor, FL
Dec 9, 2008
#2
  • Dec 9, 2008
  • #2
What year is the car?

I think that the 99 and up cars each have the sensor detect the concentration of coolant to water mix, and if it is off enough the light will trip, also, a heavy detail under the hood will throw off the sensor and make it go off.

Also, does your intake have the correct crossover?
 

paintballpyro1

Active Member
Jan 6, 2004
118
1
29
Michigan
Dec 9, 2008
#3
  • Dec 9, 2008
  • #3
I have the updated intake since the one with a plastic crossover broke. It just started doing this today after driving for 45min.
 

98COBRA281

10 Year Member
Nov 24, 2007
1,348
30
59
Port St. Lucie, Florida
Dec 9, 2008
#4
  • Dec 9, 2008
  • #4
mine got a little moisture in it, and it came on, spray a little wd-40 on the connection
 

paintballpyro1

Active Member
Jan 6, 2004
118
1
29
Michigan
Dec 9, 2008
#5
  • Dec 9, 2008
  • #5
O yea its a 96 gt btw.

Ill try using some wd-40 on the connection.I started the car after letting it sit for 5 hours and still within 1min of the car being on the light pops up.

I heard someone said it could be a blown headgasket but what are the signs? The car doesnt smoke,leak or burning fluid(which im surprised with 160k)
 

joshjwc9

Active Member
Jun 12, 2006
1,095
17
39
Palm Harbor, FL
Dec 10, 2008
#6
  • Dec 10, 2008
  • #6
A blown headgasket is a big problem, how is the car running? Check the oil or start pulling plug wires in your case to see if there is no change in idle, then that would be the cylinder that isn't firing.

No CEL codes?
 

paintballpyro1

Active Member
Jan 6, 2004
118
1
29
Michigan
Dec 10, 2008
#7
  • Dec 10, 2008
  • #7
Nope no codes, only one i think i have gotten is po1443 or something like that. Other then that the car runs fine, at times it seems like its down on power but thats it. Pulling 1 plug at a time wont hurt the car will it?
 

squeak93

15 Year Member
Jun 2, 2005
2,348
417
164
Joplin, Missouri
Dec 10, 2008
#8
  • Dec 10, 2008
  • #8
U really need to do a compression and leak down test to see if thats a prob. U can have a blown head gasket and not have oil and water mixing. It could of blown in between cylinders or a water jacket could of blown.

Is there any smell of coolant?
 

paintballpyro1

Active Member
Jan 6, 2004
118
1
29
Michigan
Dec 10, 2008
#9
  • Dec 10, 2008
  • #9
Nope no smell of coolant
 

Jinx

I like cats, cats like me. Cats and I fully agree.
20+ Year Stangneter
Oct 2, 2003
12,166
4,237
223
Cat Country
Dec 10, 2008
#10
  • Dec 10, 2008
  • #10
Are the '96s different from the '95s?? When mom had her 95 the sensor was designed into the cap (I think). Anyway, hers was doing the same thing, I just took a soft wire brush and cleaned the contacts and it was good to go (no more coolant light)
 

paintballpyro1

Active Member
Jan 6, 2004
118
1
29
Michigan
Dec 10, 2008
#11
  • Dec 10, 2008
  • #11
i believe they are, mine has the sensor on the bottom of the overflow/reservoir tank. I looked at the connector on mine and took a hairdyer and kinda dried the sensor(had a little water on it) and its contacts as well as the plug end and took the plug apart and scraped the contacts and ran it for 2-3min and the light didnt come on but havent let it run and just tried again just let it run while i walked to the mailbox down a couple houses(like 5min) and light still didnt come on so maybe it was just water? cause it was raining a bit and there were some big puddles(pretty decent) i drove through.
 

squeak93

15 Year Member
Jun 2, 2005
2,348
417
164
Joplin, Missouri
Dec 10, 2008
#12
  • Dec 10, 2008
  • #12
95-96=totally different set ups and motors.
 
You must log in or register to reply here.

Similar threads

I
Engine Help requested in identifying how to resolve engine light issue
  • Ianslaney
  • Oct 4, 2026
  • SN95 4.6L Mustang Tech
Replies
1
Views
167
SN95 4.6L Mustang Tech Oct 4, 2026
Bullitt347
Electrical Issues with my 2006 mustang gt
  • VerneVdV
  • May 22, 2026
  • 2005 - 2009 Specific Tech
Replies
0
Views
197
2005 - 2009 Specific Tech May 22, 2026
VerneVdV
E
2007 GT Stalls when lights or a/c turned on
  • ejscarfo
  • Jun 22, 2026
  • 2005 - 2009 Specific Tech
Replies
3
Views
335
2005 - 2009 Specific Tech Sep 26, 2026
manicmechanic007
F
Fox 1990 Mustang GT 5.0 A9L – Engine suddenly shuts off but immediately restarts when key turned
  • FishermansFriend
  • Aug 9, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
16
Views
652
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 30, 2026
General karthief
A
Rough idle - cylinder 1 and 6 misfire HELP
  • austindavies935
  • Jul 24, 2025
  • SN95 4.6L Mustang Tech
Replies
12
Views
861
SN95 4.6L Mustang Tech Jul 24, 2025
gkomo
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?