Lower Intake Manifold Leak

hectanooga

New Member
Jun 20, 2006
2
0
0
So, as the title says I have a lower intake man. leak on my 5.0. Well, before I rip it all apart and put in new gaskets should I try just to retorque the bolts on the lower? Also, if I do this, what is the best/easiest way to retorque the lower manifold bolts. My Haynes manual mentions that this should be done after assembly while the engine is hot. Does the upper need to be removed again?

Just a bit of history... I just bought this car and its been on the road with a rebuilt '95 motor for about 8k miles. The vacuum leak has been around for a while, just not too big a problem. Now it is a big leak and the car doesn't like to idle.

Any input or ideas would be great
Thanks
eric
 
Yeah, I'm going to go ahead and put in new gaskets this Saturday. I got some Felpro gaskets, so hopefully this will do the trick. As for the end seals on the front and back of the block... should I use the rubber gasket or should I use RTV? I have been hearing alot of people recommend just RTV, but I'm not sure.
 
If you get the U-shaped rubber gaskets for the front and back of the lower intake then use those. They seem to stay in place pretty well.
If you end up with just the cork gaskets then toss them in the trash and just use silicone.

It can still be a little tricky to get the silicone to seal just right. Get the mainifold on while the surface of your silicone bead is still wet.


Does anyone have a part number for the rubber U-shaped gasket for both the 302 and 351w?


jason