MAC control arms
- Thread starter Bad92GT
- Start date
DMAN302
My mom says thanks for the pearl necklace.
I run them and really find them a nice improvement over stock. Aside from the PITA install...they are an affordable upgrade and really help with the rear end when under throttle. Not being a road or drag racer I was not concearned with the "best of the best" mentality...there are definatly better pcs available, but for me these met my needs perfectly. I would recommend getting a fresh set of axle bushings from the local parts store prior to the install...you'll be glad you did when you get the uppers off and see their condition. You can also take a look at torque box reinforcments as an option if your into drag racing and or launching on sticky tires.
Not something i'd use. I would do something with a sperical bearing on both sides.
I run MM lowers that have sperical on one side and 3 piece poly/rubber on the other. I will be doing a set of upr double adj uppers soon with sperical on both sides. Now is a good time to buy a torque box reinforcement kit.
I run MM lowers that have sperical on one side and 3 piece poly/rubber on the other. I will be doing a set of upr double adj uppers soon with sperical on both sides. Now is a good time to buy a torque box reinforcement kit.
Yep, I have complete spherical setup on my car, and it was an amazing difference, you wouldn't believe it. I had MAC upper and lowers on my 83, and I, to tell you the truth, didn't notice ONE difference after I installed them. I still had wheel hop also. With these, it was a night and day difference. You wanna do this job once, so do it right the first time!!! 
Nick
Nick
Similar threads
