Mac Shorty Headers

B

boricuaitaliano

New Member

Jun 28, 2004

39

0

0

Jul 9, 2004

#1

• Jul 9, 2004

• #1

I have been working on installing Mac Shorty headers and H Pipe for about two weeks and gladly to say, I think I am finish. After installation I fired up my car and noticed more smoke coming from the passenger side then the driver side so I tuned it off 5 minutes from running. I do understand the headers will smoke from grease and stuff. I didnt hear any ticking noise but noticed severe smoke leaking from headers or H Pipe.
Is this normal or should I let my car run longer to see if smoke stops or tighten my bolts?

 

1

1hot5.0

Founding Member

Sep 6, 2002

1,615

0

0

Surprise, Arizona

Jul 9, 2004

#2

• Jul 9, 2004

• #2

You had your car running for 5 minues and it still smoked? Make sure all your bolts are tight (just don't snap any studs) and take your car for a short trip around the block. That's all I could think of. Maybe someone else will chime in?

 

Q

Quick5pnt0

Founding Member

Aug 21, 1999

1,208

0

36

north eastern PA

Jul 9, 2004

#3

• Jul 9, 2004

• #3

On my last car i installed the shorty headers and drove it for about five minutes and when i brought it back and let it idle it was still smoking. More than likely if you dont hear ticking or if the car hasn't become extremely loud after the install its probably just the grease on them.
If you hear ticking or if the car seems really loud now then it's a leak.

 

VibrantRedGT

"STANGNET'S PENGUIN SMACKER"

15 Year Member

Nov 29, 1999

14,679

424

154

Boca Raton, Florida

Jul 9, 2004

#4

• Jul 9, 2004

• #4

The smoke is normal. It will stop after all the grease and dirt are completely burned off.

 

B

boricuaitaliano

New Member

Jun 28, 2004

39

0

0

Jul 9, 2004

#5

• Jul 9, 2004

• #5

Okay,
I was just worried because the passenger side was smoking more then the driver side and the garage was filled with smoke exhaust. I am going to tighten them again just to make sure. Also on the passenger side there is this long pipe piece that comes from the header to the engine, what is that? I have some smoke coming from there as well.
Let me ask you guys this question:
Was I suppose to torque the headers? Because if I am suppose to I didn't, reason being I couldn't get sockets in the bolts because of the fat tubing.
Joe.

 

Q

Quick5pnt0

Founding Member

Aug 21, 1999

1,208

0

36

north eastern PA

Jul 9, 2004

#6

• Jul 9, 2004

• #6

Nobody torques their header bolts so don't worry about that, just snug 'em down.
That tube is the EGR (exhaust gas recirculation) tube, and again it's probably just the grease.

 

B

boricuaitaliano

New Member

Jun 28, 2004

39

0

0

Jul 9, 2004

#7

• Jul 9, 2004

• #7

Thnx quick5.0,
I will do that tonight because I need to fix the H pipe tomorrow at a muffler shop and get a clutch job done tomorrow.
Joe.