• Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech

maier leafs or grabatrak?

  • Thread starter Thread starter jintfan53
  • Start date Start date Dec 27, 2007
J

jintfan53

New Member
Nov 10, 2004
11
0
0
Dec 27, 2007
#1
  • Dec 27, 2007
  • #1
i have a 68 coupe with a 289. I have maier racing front coils and billstein shocks. Would the maier racing rear leafs be a big upgrade over grab a trac leafs? Also, should i go with billsteins all around or are there more cost effective rear shocks that would perform similarly. I dont forsee much track time or road racing with the car. I just want a good performing street vehicle. Any help would be greatly appreciated. Thanks a lot
 

Pbum5

Member
Oct 27, 2004
515
0
17
Minneapolis, MN
Dec 27, 2007
#2
  • Dec 27, 2007
  • #2
I have Maier 165 rear leafs in my car. They did a great job of eliminating wheel hop from my old springs. They did drop he rear a bit so I have to cut my front springs to adjust the level. They are a bit stiff for some, I am running KYB Gas-Adjust on all 4’s so maybe going to a softer shock would help a bit.

Never used grab-a-trac, but I would buy Maier’s again.

Maybe the 160's would work better for your ride. Call them and they can help you.
 
J

jamison42166

Member
Jun 13, 2006
112
0
16
Dec 27, 2007
#3
  • Dec 27, 2007
  • #3
I have the Maier 200 lb mid eye race springs in the back of my 64 1/2 restomod.
back in 06 i redid the front end with TCP coilovers which lowered the front 2.5 inches. when i got the car i put 68 stock big block leafs on it which raised the rear about an inch over stock height... putting the maier leafs lowered the car 1 inch from stock height. now the stance is where i want it, the car is a bit stiff considering the shape of the roads here but it is fun in the twisties.
I talked with Mike Maier about my setup and he recommended replacing the koni shocks with bilsteins which made a big difference in ride quality. the konis were just too damned choppy.
Maier racings CS was great and i even got a hand signed card from Mike at christmas time. I dont have any expericence with the grabatracks but maiers did cut down on wheel hop.

hope this helps
happy holidays
Jamie
 
J

Jimmys66

Founding Member
Nov 28, 2001
419
0
0
Paw Paw MI
Dec 27, 2007
#4
  • Dec 27, 2007
  • #4
Most of us that bought the maier springs have had wheel hop issues and I'll be willing to bet that most of us are stick shift guys.

The automatic guys don't seem to have wheel hop as bad.

If you have the grabas' and they work fine then leave them in. If you are buying a set anyways, I'd do the Maiers.

As for shocks, I'd match the fronts. Maier has spent alot of time figuring out what works on a mustang to make it work well.
 
J

Jimmys66

Founding Member
Nov 28, 2001
419
0
0
Paw Paw MI
Dec 27, 2007
#5
  • Dec 27, 2007
  • #5
I talked with Mike Maier about my setup and he recommended replacing the koni shocks with bilsteins which made a big difference in ride quality. the konis were just too damned choppy.


So, you like the ride quality better with the bilsteins?

I'm running the 580-700 variable coil and a 165 out back with a set of edelbrock IAS shocks. The car handles fantastick but the shocks seem a little stiff for the street. Did you notice any loss in handling after the switch to the softer bilsteins?
 
J

jamison42166

Member
Jun 13, 2006
112
0
16
Dec 27, 2007
#6
  • Dec 27, 2007
  • #6
no real loss in handling , the car seems more steady because it is able to react more to changes in roads rather than bounce over them. Mike maier also gave me really good advice on setting the compression/ rebound adjustments on the TCP coilovers. basically he said that most people set them in the middle to start. I ended up using the loosest setting on the compression and the stiffest on the rebound. I do have the C4 auto but its been beefed up and has very firm shifts. I also went with a 3.80 limited slip instead of the 2.89 open rear end. edit: ill have to snap a good photo of the leafs they are clones of the chrysler super stockers.
 
J

jintfan53

New Member
Nov 10, 2004
11
0
0
Dec 28, 2007
#7
  • Dec 28, 2007
  • #7
thanks for the advice guys. I'll probably just go with the maier leafs and billsteins.
 
You must log in or register to reply here.

Similar threads

O
Help
  • OnisimusD
  • Oct 13, 2025
  • 1965 - 1973 Classic Mustangs -General/Talk-
Replies
16
Views
386
1965 - 1973 Classic Mustangs -General/Talk- Oct 14, 2025
OnisimusD
O
New Products From J&M Products - 1979-1998 & 1999-2004 Race/Extreme Duty Rear Lower Control Arms
  • J&M Products
  • Oct 9, 2025
  • Vendor Sponsor Forums
Replies
0
Views
249
Vendor Sponsor Forums Oct 9, 2025
J&M Products
J
What's it Worth? Cobra IRS
  • johnnyj331
  • Aug 25, 2025
  • What is it Worth?!?!?
Replies
1
Views
205
What is it Worth?!?!? Aug 25, 2025
Noobz347
G
Expired 2013 Ford Mustang V6 (Grabber Blue) 3:55 gears... Excellent Condition.
  • Grabberblueguy77
  • Nov 19, 2025
  • S197 Mustangs For Sale (2005-14)
Replies
2
Views
437
S197 Mustangs For Sale (2005-14) Mar 11, 2026
Grabberblueguy77
G
S
SOLD 1967 1968 Mustang Fender Flare Kit, Maier Racing Fiberglass - $675 (Richmond)
  • steinsk
  • Dec 6, 2023
  • Interior Exterior Parts
Replies
3
Views
2K
Interior Exterior Parts Jul 25, 2025
steinsk
S
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1965 - 1973 Classic Mustangs -General/Talk-
  • Classic Mustang Specific Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?