Mis-understood ARP head bolt instructions...

[sn9550]

I mis-understood the instructions and torqued all the 7/16 head bolts to 85lbsft. I believe they were refering to cast iron with 30wt oil now not aluminum. I know the manual says one torque figure, AFR says 70/80 lbft., and ARP says 60lbft.
So do I:
a - leave them alone?
B - loosen and retorque bolts?
c - buy new head gaskets and do it over?

 

[TC93]

When doing my head studs I did same thing, torqued them to the 30wt oil specs but used ARP lube. I left them alone and haven't had any problems...

 

[sn9550]

I don't feel so bad now that I know someone else made this mistake.

 

[TC93]

Getttin in a hurray,, for some reason I get impateint working on my car. But when working on other people's I take my time,, can't figure why yet, but my guess is,, I want mine done, so I can drive it...