MM CC plate install

smokin joe · May 8, 2012

My car is a 93 LX 5.0, 5 speed hatch.

I am in the process of installing MM CC plates on my car along with Tokico blues, Bullitt springs and poly ISO's. I am confused about the spacers. With the Bullitt springs should I go with 1 small spacer on top with 1 small spacer and 2 large spacers on the bottom as recommended in the instructions?

Any help is appreciated.

Gearbanger 101 · May 8, 2012

I don't have an answer for you, but I want picturs of your set up when it's done. Curious to see what the ride height is like?

foxna6 · May 8, 2012

Yes one small spacer on top worked in my car just make sure to check your hood clearance don't just slam it shut

smokin joe · May 8, 2012

Gearbanger 101 said:
I don't have an answer for you, but I want picturs of your set up when it's done. Curious to see what the ride height is like?

Mustang5L5 has mach 1 springs on his LX. Skunk 21 has Bullitts on his GT. They both have posted pictures of their cars. I liked the way their cars looked so I decided to go with the same set up.

smokin joe · May 8, 2012

foxna6 said:
Yes one small spacer on top worked in my car just make sure to check your hood clearance don't just slam it shut

Thanks! Right now I have 1 large and 1 small on top, 1 large and 1 small on bottom. I put play dough on top and slowly closed the hood. I measured it and it came out to about 1/8". I know Bullitts will lower the car slightly, but not slam it. That is why I was curious.

MM CC plate install

smokin joe

Gearbanger 101

Straight Outta Locash

foxna6

Member

smokin joe

smokin joe

Similar threads

MM CC plate install

smokin joe

Gearbanger 101

Straight Outta Locash

foxna6

Member

smokin joe

smokin joe

Similar threads

Privacy & Transparency

Privacy & Transparency